Find An Answer

Browse our vast Answer database for answers to many common technical questions.
Results per page: 10 25 50 100
Acoustic Echo Cancellation and Noise Reduction in MXA310 and MXA910 microphones.
June 20, 2019

Beginning with firmware v4.0, the MXA910 has AEC and Noise Reduction built in as part of the IntelliMix® DSP suite, which can improve smaller ...

Why does the AES67 tab not show up?
June 6, 2019

Please try the following: Try toggling "Use shared Dante Interface" in Dante Controller's Choose Interface window. This is found b ...

GLX-D firmware update
May 23, 2019

If the blue rf light is blinking and there is no audio you will need to update your components to the latest firmware. Download the Shure Update ...

CR81 and other OEM Models - Hercules or Rex
May 23, 2019

This microphone was an OEM (Original Equipment Manufacturer) model, i.e., Shure made the microphone for another equipment manufacturer. The CR81 ...

SM7B Output Level and Preamp Gain Specifications
May 23, 2019

The SM7 (SM7A, SM7B) is a dynamic microphone. A typical dynamic mic has a lower output level than a typical condenser mic. For example, the dynamic ...

Twinplex ear mount
May 23, 2019

A few of you have asked whether we sell the "ear rig" that you see in some of the theater images for TwinPlex, models TL45, TL46, TL47, TL48 ...

How do I install an FL6000 feature license on a DIS-CCU?
May 13, 2019

Steps to load an FL6000 license file: Unzip the folder mentioned above and place the *.xml file inside where you can find it (Desktop, for examp ...

I have never installed SW6000. What do I need to know before proceeding?
May 13, 2019

IMPORTANT: IF THIS ORDER IS FOR AN UPGRADE TO AN EXISTING SYSTEM, PLEASE BACKUP YOUR SW6000 DATABASE OR CONTACT SHURE SUPPORT TO ASSIST BEFORE PROCEED ...

Microphone for percussion
April 18, 2019

See our online selection guide. ...

Replacement Stylus for Different Brands
April 18, 2019

Thank you for your inquiry concerning Shure phonograph products.Shure styli will only fit Shure cartridges. So we cannot recommend a substitute Shure ...

Stereo pairs using KSM32 or KSM44
April 18, 2019

You are correct. For a stereo recording, you would need to use a pair of KSM44's. We agree that the difference in sound between the KSM32 and the ...

Battery Powered Phantom Power Supply with Balanced Output
April 18, 2019

The schematic below illustrates an 18 volt phantom supply. It will supply any Shure microphone that requires phantom power. Battery life is dependent ...

Preamp for SM91 microphones
April 18, 2019

Do you still have the in-line battery driven preamps? If yes, they can be powered via phantom power. If no, the placement preamp is the RPM628. This i ...

Multiple mics into one receiver?
April 1, 2019

Every transmitter must operate on its own frequency. That means there must be a corresponding receiver for each individual transmitter. That receiver ...

Custom molds for earphones: how to, what, and where?
February 11, 2019

Custom sleeves offer the ultimate in personal fit, and in some cases offer even better sound isolation than the universal sleeves included with Shure ...

Do the SM58 and SM57 mics have the same frequency response curves?
January 15, 2019

The SM58 and SM57 do use the same cartridge. The grill, though, does affect the frequency response to some extent. At a distance, the difference is pr ...

How do I connect a professional microphone to a camcorder?
December 6, 2018

Connecting Microphones to CamcordersThere are many interfaces by the likes of Beachtek, Marantz, Kopul, Saramonic, etc. on the market to help connect ...

What is Phantom Power?
October 26, 2018

Phantom power is used with condenser microphones. It is called phantom power because there is no obvious external power supply for the condenser mic; ...

545 or 565 mic with the 4 pin Amphenol connector
September 20, 2018

We can tell you what pins to use at the microphone connector. Your 545 microphone has a four pin MC4F Amphenol connector. Pins 1 and 2 of this connect ...

545 and 550S adapters?
September 20, 2018

There is a supplier for such cables. Contact Tom Ellis: phone - 214-328-3225; email - tellis@ellisandassoc.comTom sells cables that have Amphenol conn ...

PE585 replacement cable
September 20, 2018

Shure no longer stocks this cable.Try Tom's Mics - Mr. Tom Ellis - phone 214-328-3225 tellis@ellisandassoc.comTom offers cables for many discontinued ...

Retro parts for an Shure 55AV
September 20, 2018

Unfortunately all such parts are long gone at Shure.You might have luck with collectors of old mics. We suggest you start with Tom Ellis: tellis@ellis ...

Mic cable for Shure 55S
September 20, 2018

The 55S used a 3 pin Amphenol connector, part #MC3M. We do not carry these connectors, but you can get pre-wired cables from Tom Ellis (214-328-3225 o ...

I need a connector (audio) for my old model 51 microphone.
September 20, 2018

The connector on the 51 is an Amphenol MC3M. We do not carry these connectors,You can get pre-wired cables from Tom Ellis(214-328-3225). ...

Harmonica Breathing Noise With 520DX
September 20, 2018

This is a playing technique problem. In brief, a microphone is designed to change air movement into an equivalent electrical signal. A microphone cann ...