Find An Answer

Browse our vast Answer database for answers to many common technical questions.
Results per page: 10 25 50 100
Replacement Stylus for Different Brands
April 18, 2019

Thank you for your inquiry concerning Shure phonograph products.Shure styli will only fit Shure cartridges. So we cannot recommend a substitute Shure ...

Stereo pairs using KSM32 or KSM44
April 18, 2019

You are correct. For a stereo recording, you would need to use a pair of KSM44's. We agree that the difference in sound between the KSM32 and the ...

Battery Powered Phantom Power Supply with Balanced Output
April 18, 2019

The schematic below illustrates an 18 volt phantom supply. It will supply any Shure microphone that requires phantom power. Battery life is dependent ...

Preamp for SM91 microphones
April 18, 2019

Do you still have the in-line battery driven preamps? If yes, they can be powered via phantom power. If no, the placement preamp is the RPM628. This i ...

WA874ZP Cover for Directional Antenna
April 18, 2019

Yes.  The WA874ZP cover was introduced in the Spring 2013.  It is moisture-resistant, but not moisure-proof as it has a zippered opening for ...

HTS (Home Theater System) Manuals
April 8, 2019

HTS50SPA Power AmplifierHTS50CF Center Front Speaker SystemHTS50SW Subwoofer SystemHTS5000 Surround Audio ProcessorHTS5000 Service InformationHTS5300 ...

Fix for SRH440 mechanical noise
April 2, 2019

1) One SRH440 owner reported success in eliminating a "creak" by spraying silicone lubrication (sold at hardware stores) on the moving joint ...

Multiple mics into one receiver?
April 1, 2019

Every transmitter must operate on its own frequency. That means there must be a corresponding receiver for each individual transmitter. That receiver ...

SM7B Output Level and Preamp Gain Specifications
March 20, 2019

The SM7 (SM7A, SM7B) is a dynamic microphone. A typical dynamic mic has a lower output level than a typical condenser mic. For example, the dynamic SM ...

Why does the AES67 tab not show up?
March 7, 2019

Please try the following:Try toggling "Use shared Dante Interface" in Dante Controller's Choose Interface window. This is found by cklicking ...