Shure Europe | WL93 Series Subminiature Lavalier Microphones

PGX Wireless

Downloads: User Guide

Add To Favorites

Remove From Favorites

OmniDirectional Polar Pattern: Equally sensitive to sound from all directions, but cannot be "aimed" to isolate one area.

WL93Series Subminiature Lavalier Microphones

Shure

Condenser: Lightweight, sensitive diaphragm. Precisely and smoothly captures sound nuances. Powered by battery or phantom power supply.

Recommended Uses: Live Vocals

Model WL93 Microphones are economical omnidirectional, subminiature, lavalier, condenser microphones designed for general speech applications where a visually unobtrusive microphone is desirable. All WL93 models are supplied with a mounting block with attached tie bar, a sew-on mounting bracket, and an acoustic windscreen to minimize wind noise in outdoor applications. All WL93 models include a cable terminated with a 4-pin mini connector which connects directly to a Shure wireless body-pack transmitter.

Available Options

WL93	Black, w/ 4-foot (1.2 m) Cable
WL93-6	Black, w/ 6-foot (1.9 m) Cable
WL93T	Tan, w/ 4-foot (1.2 m) Cable
WL93-6T	Tan, w/ 6-foot (1.9 m) Cable

Go Wireless View wireless systems that include a wireless version of this microphone

Subminiature lavalier design; ideal size for theater, television, broadcasting, video, film, and sound reinforcement
Small, inconspicuous mounting hardware
Full, clear sound comparable to larger microphones
Smooth extended frequency response with presence rise specially tailored for chest-worn microphone operation
Controlled low-frequency rolloff reduces low-frequency clothing and room noise

Low distortion, wide dynamic range
Uniform omnidirectional polar pattern
Preamplifier assembly (SM93) can be pocketed, strapped to the body, or clipped to belt or waistband
Wide-range phantom powering (SM93) accepts all commonly used voltages

Type: Condenser (electret bias)
Frequency Response: 50 to 20,000 Hz; View Larger
Polar Pattern: Omnidirectional, uniform with frequency
Output Impedance: 3000 ohms
Output Level (1 Pascal = 94 dB SPL): Open Circuit Voltage: -38 dBV/Pa (13 mV)
Output Clipping Level (at 1,000 Hz): 0.25 V at 120 dB
Total Harmonic Distortion: Less than 1% at 120 dB
Maximum SPL: 120 dB
Dynamic Range (maximum SPL to A-weighted noise level): 102 dB
Output Noise (equivalent SPL): 18 dB typical, A-weighted
Signal-to-Noise Ratio: 76 dB at 94 dB SPL (IEC 651)

Polarity: Positive pressure on microphone diaphragm produces positive voltage on pins 3 and 4 with respect to pin 1 (ground)*; *Produces positive voltage at pin 2 of Shure wireless receiver three-pin connector
Recommended Operating Voltage: 2 to 10 V; 5 V nominal (pin 2 to pins 3 and 4)
Current Drain: 40 microA typical
Environmental Conditions: Operating Temperatures: -18 to 57 degrees C (0 to 135 degrees F); Storage Temperatures: -29 to 74 degrees C (-20 to 165 degrees F)
Cable: Black 1.27 m (4.17 ft), attached, two-conductor, shielded, terminated by miniature connector type TA4F (WL93T: Tan 1.27 m [4.17 ft])
Case: Microphone: Black ABS thermoplastic case with stainless-steel-mesh grille
Net Weight: Microphone: 16 g (0.57 oz)

	shName	Availability
	RK354SB Microphone Tie Clip Microphone Tie Clip for Shure WL93 and SM93 microphones. Available in black.	Where To Buy
	RK304T Tan Foam Windscreens & Tie Clips Tan Foam Windscreens & Tie Clips for the Shure SM93 and WL93 microphones (contains two of each).	Where To Buy
	RK355WS Microphone Windscreens Reduces unwanted breath and wind noise and for use with the Shure SM93 and WL93 lavalier microphones (contains 4). Available in black.	Where To Buy
	RK307DB Dual Microphone Tie Clips Dual Microphone Tie Clip for the SM93 and WL93 microphones (contains two).	Where To Buy