Restricting the SLX 1 Bodypack Gain Switch

FAQ #3030 Updated October 27, 2008

Question:

After setting my SLX1 transmitters to "0" position, and placing transmitters on performers, one of the SLX systems was clipping. After the performance, I found that the transmitter sensitivity switch had accidentally been switched to the "MIC" position; it should have been in the "0" position. I believe this was the result of the performer adjusting the bodypack on his waistband. For later shows, I put a piece of tape over the switch to protect the setting. Any other suggestions?

Answer:

From a plastic milk jug, cut a small rectangular piece of plastic to fit into the switch recess. This piece will act as a physical barrier against movement of the switch when jammed against the switch and the side of the recess.

Find an Answer

Related Products

SLX

Contact Information

Telephone: (800) 516-2525

Fax: (847) 600-8686

Additional Support

Ask a Question