PA213 Cable Information
PA213: This cable is designed for the guitarist who is completely wireless and uses a P2R for their monitor and a body pack transmitter that takes a 1/4" jack as input. This cable allows a guitarist to control their own level in their monitor mix and still have a wireless transmitter split. The cable assembly is designed to allow a guitarist to split their guitar output into two separate signals that would feed the P2R Aux Input and a body pack transmitter as well. The cable assembly consists of 2 male mono 1/4" connectors, 1 male 1/4" TRS connector, a preamp and a splitter board. The split that feeds the P2R Aux input passes through the inline preamp. This provides the user with a 6dB gain with adjustable output level through a thumbwheel potentiometer. This allows the performer to control how much of their guitar signal is fed into their P2R Aux input. The preamp also provides a 3dB down point at 52Hz. The input impedance is approximately 500Kohms.
- Provides split for guitar signal to feed P2R Aux input and 1/4" input body pack transmitter.
- Preamp provides 6dB gain, output level adjusted through thumbwheel control, to split fed into P2R Aux input.
- "Zero" Position on Preamp will not pass any audio to P2R.
- Provides 52Hz 3dB down point.
- Preamp input impedance is approximately 500kohms.
- Cable lengths provide convenient cable management for performers.
- Over molding of Splitter PCB provide rugged Y Junction.
- Provides 1/4" male jack to feed body back transmitter.