EZG Easyflex Gooseneck Microphones

This product has been discontinued.  For alternate installed sound solutions, please see Shure Microflex.

(Discontinued)  The Easyflex® line of miniature gooseneck condenser microphones are the ideal solution for podiums, desk applications, recording, and other speech and vocal sound reinforcement.

The Easyflex® line of miniature gooseneck condenser microphones are the perfect choice to capture speech and vocals in environments where quality, value and budget are primary considerations. The gooseneck condenser microphones feature a cardioid polar pattern, and are available in four different models, dependent on height and mounting application.

Available in either 12" or 18" lengths, each charcoal gray microphone comes standard with a single flexible gooseneck section for ease in accurate positioning, as well as a matching slip-on foam windscreen. Choose a locking flange mount with an integrated preamplifier and XLR connector for easy permanent install. Or choose side-exit mounting with 10-foot cables, in-line preamplifiers and threaded mounting flanges - easily adaptable to a standard microphone stand.

• EZG/12 - with 12 inch (30 cm) gooseneck, attached preamp with XLR, locking flange mount and windscreen
• EZG/18 - with 18 inch (45 cm) gooseneck, attached preamp with XLR, locking flange mount and windscreen
• EZG/12SE - with 12 inch (45 cm) gooseneck, 10 foot side side-exit (or bottom exit) cable, in-line preamp with XLR, threaded mounting flange, and windscreen
• EZG/18SE - with 18 inch (45 cm) gooseneck, 10 foot side side-exit (or bottom exit) cable, in-line preamp with XLR, threaded mounting flange, and windscreen

• Single gooseneck section near microphone base for easy orientation of the microphone.
• Tubular preamp body sized to fit many standard accessories.
• Slide-on windscreen.
• (SE) 5/8–27 threaded nut with cable exit provides a variety of mounting possibilities.
• EZG/18SE offers extended length for greater positioning range
• (SE) External preamp reduces visible size of the microphone.

Specification Sheet (pdf)

 

Frequency Response

50 to 17,000 Hz

 

view larger

 

Polar Pattern

Cardioid

 

Output Impedance (at 1 kHz)

Rated at 150 ohms (180 ohms actual)

 

Open Circuit Sensitivity (at 1 kHz, ref. 1 V/Pascal*)

-45.7 dB (5.19 mV)

*1 Pascal = 94 dB SPL

 

Maximum SPL (1 kHz at 1% THD, 1 kilohm load)

129 dB

 

Equivalent Output Noise (A-weighted)

29 dB SPL

 

Signal to Noise Ratio (referenced to 94 dB SPL)

65 dB

 

Dynamic Range (at 1 kilohm Load)

100 dB

 

Common Mode Rejection

45 dB minimum

 

Preamplifier Output Clipping Level (1 kHz at 1% THD, 1 kilohm load)

-12.0 dBV (0.25 V)

 

Polarity

Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output connector.

 

Power Requirements

11 to 52 Vdc phantom, 2.0 mA

 

Environmental Requirements

Operating Temperature Range: -18 degrees C to 57 degrees C (0 degrees F to 135 degrees F)

Relative Humidity: 0 to 95%

• Microflex
• RF and GSM Resistance