PSM 700 Wireless Personal Monitor System with SCL3 Earphones, P7TRE3

The PSM®700 series offers advanced controls and features that make it easy to quickly locate and lock in the clearest frequency, prevent distortion and minimize the number of antennas required to send mixes.

• PSM 700 P7TRE3 Wireless Personal Monitor System: Consists of the P7T Wireless Transmitter, the P7R Wireless Bodypack Receiver, and gray SCL3 Sound Isolating Earphones.

The PSM 700 P7TRE3 Wireless Personal Monitor System consists of the P7T Wireless Transmitter, the P7R Wireless Bodypack Receiver, and gray SCL3 Sound Isolating Earphones.

P7T Wireless Transmitter

Key Features

• Built-in audio limiter
• Internal power supply
• 1/2 rack space
• Remotable/combinable antennas

Operating Controls

• Input level knob
• Operating mode (Stereo, Mono, MixMode)
• Earphone volume knob
• Channel selector
• Group select switch

LED Indicators

• 8-segment input level
• Frequency group

P7R Wireless Bodypack Receiver

Key Features

• Frequency locator
• Dynamic overload protection
• Rugged metal chassis

Operating Controls

• Operating Mode (Stereo, Mono, MixMode)
• Volume knob
• Balance knob
• Defeatable limiter
• High-frequency boost
• Channel selector
• Group select switch

LED Indicators

• Power
• RF reception
• Low battery

Spec Sheet (pdf)

CAD drawing (zip)

PSM 700 P7TRE3 Wireless Personal Monitor System

RF Carrier Frequency Range

524 - 865 MHz (Available frequencies vary, depending on applicable regulations in the country where the system is used)

 

Operating Range

90 m (300 ft.), under optimum environmental conditions

 

Audio Frequency Response

50 to 15k Hz (+0, ­3 dB @1 kHz); earphone dependent

 

Image Rejection

80 dB typical

 

Spurious Rejection

80 dB typical

 

Total Harmonic Distortion (@1 kHz)

0.8% typical (Ref. +/- 35 kHz deviation)

 

Modulation

FM +/- 35 kHz deviation (nominal), MPX Stereo

 

Channel Separation

35 dB typical

 

Signal-to-Noise Ratio

80 dB typical (A-weighted)

 

Operating Temperature

­7 degrees C to +49 degrees C (+20 degrees F to 120 degrees F)

NOTE: Electrical safety approval is based on a maximum ambient temperature of 35 degrees C.

 

Battery Life

4­6 hours, volume dependent

 

Polarity

P7T audio inputs to P7R audio outputs: Non-inverting

XLR: pin 2 positive with respect to pin 3

1/4 in TRS: Tip positive with respect to ring

RF Sensitivity

0.7 µV typical

 

Squelch Threshold

2 µV typical

 

Antenna Input Impedance

50 ohms typical

 

Antenna

External, threaded connector

 

Power

9 V battery (alkaline recommended), 4­6 hours (volume dependent)

 

Audio Output Connector

3.5 mm Stereo (Left = tip, Right = ring, Ground = sleeve)

 

Minimum Load Impedance

16 ohms

 

Net Weight

0.23 kg (0.52 lbs.)

 

Overall Dimensions

27.18 mm X 64.52 mm X 85.09 mm (1.070 in X 2.540 in X 3.350 in)

RF Output Power

100 mW (+20 dBm) typical conducted, U.S.A. and Canada (varies with other countries)

 

Modulation Limiter

Internal peak limiter (>10:1 compression)

 

Antenna

External whip, 50 ohm BNC connector

 

Power Requirements

P7T: 90­120 VAC, 50/60 Hz

EP7T: 220­240 VAC, 50/60 Hz

NOTE: This product is not disconnected from the mains power supply when the power switch is in the OFF position.

 

Current

115 mA maximum at 120 VAC

55 mA maximum at 230 VAC

 

Fuse

P7T: 90­120 VAC, 160 mA/250 V (SLO-BLO®)

EP7T: 220­240 VAC, 80 mA/250 V time delay 5mm X 20mm

 

Dimensions

44.5 mm X 196.8 mm X 241.3 mm (1 3/4 in X 7 3/4 in X 9 1/2 in.)

 

Net Weight

1.497 kg (3 lb, 4.8 oz.)

• FAQ's for PSM 700
• PSM 700