Shure - Personal Monitor Systems - PSM 600 Wireless Personal Monitor System with SCL3 Earphones, P6TRE3

PSM 600 Wireless Personal Monitor System with SCL3 Earphones, P6TRE3

Shure's first entry into personal monitoring, the PSM®600 continues to be recognized as the industry standard for full-featured wired and wireless In-Ear systems. Rugged and reliable, they deliver superb sound for all professional broadcast, recording, touring and installed sound applications.

The PSM 600 features crystal-controlled analog operation for superior sound quality. It delivers a full frequency range and great stereo separation. Even the deepest bass notes come through loud and clear.

PSM 600 P6TRE3 Wireless Personal Monitor System: Consists of the P6T Wireless Transmitter, the P6R Wireless Bodypack Receiver, and gray SCL3 Sound Isolating Earphones.

The PSM 600 P6TRE3 Wireless Personal Monitor System consists of the P6T Wireless Transmitter, the P6R Wireless Bodypack Receiver, and gray SCL3 Sound Isolating Earphones.

P6T Wireless Transmitter
	*Key Features*
	Built-in audio limiter 1/2 rack space Internal power supply Remotable/combinable antennas
	*Operating Controls*
	Input knob Operating mode (Stereo, Mono, MixMode) Earphone volume control Frequency select switch
	*LED Indicators*
	8-segment input level Frequency
	*Inputs*
	Two line level XLR 1/4" combos
	*Outputs*
	Two 1/4" TRS loop outs Local earphone monitor

P6R Wireless Bodypack Receiver
	*Key Features*
	Rugged metal chassis
	*Operating Controls*
	Operating mode (Stereo, Mono, MixMode Volume knob Balance knob Defeatable limiter High frequency boost Frequency select
	*LED Indicators*
	Power RF reception Low battery

SCL3 Sound Isolating Earphones
Single WideBand Microdrivers with incredible isolation for detailed tone across the frequency range.
	Specifications
	Frequency Range: 25Hz – 18.5kHz Sensitivity (at 1 kHz): 115 dB SPL/mW Impedance (at 1 kHz) 26 ohms Weight: 28g (.9oz) Output Connector: Gold-plated stereo, 3.5 mm (1/8-inch) phone plug Cable Length: 1.57 m (62 inches)

Spec Sheet (pdf)

PSM®600 Wireless Systems

RF Carrier Frequency Range: 626 to 862 MHz (country dependent)
Audio Frequency Response: 50 to 15k Hz (+0, 3 dB re 1KHz); earpiece dependent
Operating Range: 300 ft. (environment dependent)
Modulation: FM +/- 35 kHz Deviation (Nominal), MPX Stereo
Channel Separation: 35 dB typical Total Harmonic Distortion; 0.8% typical (Ref. +/- 35 KHz deviation)
Signal-to-Noise Ratio: 80 dB typical (A-weighted)
Operating Temperature: -7 degrees C to +49 degrees C (20 degrees F to 120 degrees F)
Polarity: P6T audio inputs to P6R audio outputs: Non-inverting XLR: pin 2 positive with respect to pin 3 1/4-in. TRS: Tip positive with respect to ring

P6T TRANSMITTER

RF Output Power: 100 mW (+20 dBm) typical conducted (country
dependent)
Modulation Limiter: Internal peak limiter (>10:1 compression)
Antenna: External whip, 50 ohm BNC connector
Power Requirements: P6T: 100 to 120 Vac, 50/60 Hz; EP6T: 220 to 240 Vac, 50/60 Hz; NOTE: This product is not disconnected from the mains power supply when the power switch is in the OFF position.
Current: 115 mAac maximum at 120 Vac; 55 mAac maximum at 230 Vac
Fuse: P6T: 120 Vac, 160 mA/250 V time delay; EP6T: 230 Vac, 80 mA/250 V time delay
Dimensions: 44.5 mm X 197.4 mm X 238.1 mm (1 3/4 in. X 7 3/4 in. X 9 3/8 in.)
Net Weight: 1.62 kg (3 lbs., 9 oz.)

P6R RECEIVER

RF Sensitivity: 1.2 µV typical
Image Rejection: 70 dB typical
Spurious Rejection: 60 dB typical
Squelch Threshold: 4 µV typical
Antenna Input Impedance: 50 ohms typical
Antenna: External, threaded connector
Power Requirements: 9 V battery
Battery Life: 46 hours, volume dependent
Audio Output Connector: 3.5 mm Stereo (Left = tip, Right = ring, Ground = sleeve)
Minimum Load Impedance: 16 ohms
Net Weight: 0.52 lbs.
Overall Dimensions: 27.18 mm X 64.52 mm X 85.09 mm (1.070 in. X 2.540 in. X 3.350 in.)